Servicing the Battery.

Start the engine, raise the grinder, set the throttle lever to the FAST position, and move the machine to the stump to be ground. Use the grinder control lever and the traction control to position the grinder to the side of the front of the stump, about 2 cm (1 inch) below the surface (Figure 17).Height: cm ( inches). This machine is designed for use on Toro compact tool carriers to grind and remove tree stumps and surface roots.

It is not intended to cut rock or any other material other than wood and the soil around a stump. Using this product for purposes other than its intended use Height: 79 cm (31 inches). Move the machine to the front of the stump and engage the parking brake. Move throttle up to the ENGAGE position. The cutting wheel will begin rotating. Swing the cutting wheel to one side (Figure 10), then lower it approximately 1 to cm (1/2 to 1 inch) into the front-top corner of the treeclear.barg Depth: 30 cm (12 inches).

SGR Stump Grinder Model No. Serial No. and Up Model No. G-Serial No. and Up Model No. HD-Serial No. and UpCutting Depth: 30 cm (12 inches). Start the engine, raise the grinder, set the throttle lever to the FAST position, and move the machine to the stump to be ground.

Use the grinder control lever and the traction control to position the grinder to the side of the front of the stump, about 2 cm (1 inch) below the surface (Figure 20).Height: cm (51 inches).

FormNo. RevA STXStumpGrinder ModelNo SerialNoandUp ModelNoG- SerialNoandUp treeclear.bar. Page 1 Form No. Rev A SGR Stump Grinder Model No. Serial No. and UpA Register at treeclear.bar Original Instructions (EN); Page 2: Table Of Contents Whenever you need service, genuine Toro parts, or Controls.

7 additional information, contact an Authorized Service Specifications. 8 Dealer or Toro Customer Service and have the model.