Anyone with the best answer?

May 12, I slowed down the part where the saw kick back on me just to show everyone how fast it can happen, that's why it is always important to have two hands on you. Cutting through several pieces of timber can lead to the nose cutting into the second piece. Another way to prevent osrs cutting oak trees is how you hold the saw.

You will need to Estimated Reading Time: 7 mins. Apr 09, Your saw won’t kickback if you lead with the bottom of the bar tip, instead of the top. Practice a few, and you’ll get comfortable with it. The next time you fell a tree, leave a stump 2 to 3 feet high on which to practice bore cuts. Hold the saw to make a horizontal cut, and use your thumb on the throttle, instead of your index finger. Start a bore cut at the normal level for a back cut, again using the lower quadrant of the bar.

Bore straight in, leaving enough hinge wood for the size of the tree. Walk the saw back, cutting approximately half the tree and leaving sufficient holding wood in back.

Repeat the procedure on the opposite side.

Safety devices, maintenance and inspection Many modern chain saws have incorporated enhanced safety measures such as protective coverings for the entirety of the bar tip, low-kickback or reduced-kickback chains, and chain brakes.

Use a release cut from the back side. Feb 14, About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy & Safety How YouTube works Test new features Press Copyright Contact us Creators.

Felling Mechanics Height Of Holding Wood -- Stump Shot Or Anti-kickback Device (Perform Experiment) – Prevents Kickback From Tree Rotating About Its Center Of Mass – Prevents Kickback When Striking Another Tree In Standing Timber Width Of Holding Wood –Tree Hinged To The Stump While Falling – Controls The Direction And Fall Of The Tree – Without Holding Wood The Tree Is. Apr 09, People are often reluctant to use the bore cut because they think it leads to kickback.

Your saw won’t kickback if you lead with the bottom of the bar tip, instead of the top. Practice a few, and you’ll get comfortable with it. The next time you fell a tree, leave a stump 2 to 3 feet high on which to practice bore cuts.

7. Never cut a standing tree completely through. Leave sufficient wood be-tween the notch and the back cut for the tree to hinge on; otherwise, you may lose control of the tree and it could kick back.

8. If too much hinge is left, the tree can split and possibly barber chair. At a. Jul 17, Tips to avoid chainsaw kickback. The best protection to avoid being injured by a chainsaw kickback is to avoid situations where there is a risk of kickback: Take the chainsaw with both hands and hold it firmly. Always observe the head of the guide. Take care that the guide head never touches any object. Do not cut branches with the guide bar head.